Fins v1 Fishing Lure Waterslide Decals – Clear, 216 Pairs

Get the look of the Fins v1 stencil without the airbrush masking. Each waterslide decal sheet carries one design from our Fins v1 Assortment Fishing Lure Airbrush Stencil, printed as fin decals in mirrored left and right pairs. Choose your design above; the photo shows that sheet.

• Design 1: about 10mm x 5mm per fin
• Design 2: about 10mm x 5mm per fin
• Design 3: about 9mm x 3mm per fin
• Design 4: about 9mm x 4mm per fin

• 216 pairs per sheet: each pair is one left and one right fin, so a single pair finishes both sides of a lure
• Printed in black: the tan and red artwork in the photos is an enlarged preview of the design, not a color option
• Clear base: only the printed fin shows, so your lure’s base color shows through everywhere else
• Each design matches the same design on the Fins v1 airbrush stencil, so you can mix decals and airbrushed fins in the same color pattern

Applying waterslide decals

1. Paint and fully dry your lure. Because the decal base is clear, the fin shows up best over a light or bright base coat.
2. Cut out one decal and soak it in lukewarm water for about 20 to 30 seconds, until it slides freely on the backing paper.
3. Slide the decal off the paper onto the lure, position it, and gently blot away the water and air bubbles with a soft cloth or paper towel.
4. Let it dry completely, then seal the lure with your usual clear topcoat (epoxy, UV resin, or dip coat). Waterslide decals must be topcoated to hold up in the water.

Made and shipped in the USA. Questions or custom designs? Contact us.